Bluegill - Big Bluegill

Do you love big bluegill?

So I'll be looking to pick up a boat here in the future on the cheap.  So I need to know what to keep an eye out for.  The ability to hold 2 people is a must, but I'd like to be able to put three in it.  There will also be a child in there more often then not, so stability is nice.

 

I'm thinking a 15 or 16' flat bottom boat will work out rather nice, but I'm not sure.  Because of where I'll be fishing, I have to use electric power only.

 

What type of engines work for this size boat?  I think I'd rather spend a little extra money on the motor so I'm not traveling for as long.  The reservoirs around here are all electric only and quite large.  So I'd really like to be able to get where I need to go in a timely manner.  Of course you can't expect it to be as fast as a gas engine, but I have zero experience with these things.


Thanks

Views: 6063

Reply to This

Replies to This Discussion

Chris, I have a 1648 Alumacraft that I low decked and run total electric 95% of the time with a 55lb Minn Kota TM. There are some pictures of it on my page. It might give you some ideas. Either hull you are looking at should do fine. Good luck on your build.
Mike

I see where you say you get about 3mph on yours...  That's about all I could ask for on a 55lb thrust.  That's very much appreciated.

The carpet in your boat looks very nice (as does the entire boat).  Are you glad you put it in vs just having the ribbed floor?

Yes I get about 3 mph on electric. I put the floor in to keep the noise down in the boat, plus not tripping over ribs, which I've been known to do:). I've been happy with it. The carpet is from BPS and has stood up well for 3 seasons.

Did you secure the plywood to the boat in anyway?  Or are they removable.  I've been reading about people who have done it both ways.  I was just curious of how you did it and your opinion on it.  I think carpet is in the future for me.

Yes, I used 1/2" plywood with several coats of polyurethane before putting the carpet on. The decking is attached with stainless steel screws. The boat gets used 50 times a year or so. Everything has held up well. I either flush it out with water or use my shop vac on it to keep it clean.

Chris all good boats but then again I'm kinda parcel. Jon boats are great a boat for fishing they are stable and get into shallower water. The downsize is they don't handle rough water well and the wind will have you all over the place so you can never have to much trolling motor in this instant bigger is better. As far as the boats I'm sure the welded would be the best for you but would opt for something wider. Wider makes your boat more stable and you navigate into shallower waters. I'm seeing the G3 15 foot with a 48 inch bottom width, the 1650 16 foot 50 inch bottom width and the 1652 16 foot 52 inch bottom width all good boats. When I bought my boats the wider the better that was the way I figured it and after having a few I'm telling you wider is better but welded could illuminate lot of leakage for a dryer ride. But if your not planning on leaving it in the water it probably wouldn't be my number 1 priority. Hope I helped remember wider is better and you will never have enough power.

It's definitely down to these three boats due to funds and location.

I will store my boat in a garage so weather wont be an option (I have an old farm building).  And honestly... I think it's down to either the 1652 (three bench seat) Xpress or the 1548VBW (casting platform and rear seat) G3.  The G3 also has an aluminum floor on top of the ribs and is vinyl wrapped.

The 1652 is about $500 cheaper though.  I'm trying to talk the G3 dealer down in price a little to make it a more attractive option.

I'm also fishing pretty strictly on not so wide reservoirs so the chop never gets real bad.  I've fished some 48" boats on these before and they seem to do fine.

Chris… I have the tracker topper 1542 and I love it. Very economically priced and rugged I currently operate it with a Minn Kota 45 lb thrust transom mount that does about 3mph. two batteries and front and rear nav lights, Lowrance elite 7 sonar, aeration complete the electrical. I added a gas power 4 stroke Coleman outboard that pushes the boat at 7mph and sips the gas. The boat I added ¾ in rubber mat I bought at home depot adds cush and nearly levels out the ribs on the bottom. Added the oar locks to fish the very skinny water and add a little exercise. The boat comes with an insulated live well small but usable. I’m adding a Tohatsu 4stroke electric start outboard that should push this boat around 20mph. can’t wait for that to happen. Yaught Club trailer and added guides to the bunks. Easy load and unload even with my bad back. This was very important to me. Very, very stable on the water.
Hope this helps Good luck on your future boat

Nice ken - Im inspired

thanks McScruff

I may never get the boat I dream of - -  but if I do, it'll borrow something from this.

Ken I really like what you did with the mats here too by the way. 

RSS

Latest Activity

Jeffrey D. Abney posted a photo

Another Nice Male on the Popeye Jig…….8/18/2022

Summer winding down quickly….be shifting to fall techniques very soon….
yesterday
Jeffrey D. Abney posted photos
yesterday
Jeffrey D. Abney posted a status
"Got a few hours out this afternoon on a nice day…..bagged a limit of gills and for the first time in my life, mouth hooked several mullets.."
yesterday
John Sheehan commented on John Sheehan's photo
Thumbnail

24in Trolled

"Thanks Dick ! Not sure this is the 24 " I caught but the 24 " slammed it hard .A great…"
yesterday
dick tabbert commented on John Sheehan's photo
yesterday
Jeffrey D. Abney commented on Jeffrey D. Abney's photo
Thumbnail

Good Box of Tidal Crappie and Bonus Channel Cat……..8/16/2022

"Love them Bruce …….not discussed here a lot but I eat farm raised channel catfish…"
Wednesday
Jeffrey D. Abney commented on Jeffrey D. Abney's photo
Thumbnail

Good Box of Tidal Crappie and Bonus Channel Cat……..8/16/2022

"Thanks John……just a great fighting fish…and tasty too….."
Wednesday
Bruce Tomaselli commented on Jeffrey D. Abney's photo
Wednesday
John Sheehan commented on Jeffrey D. Abney's photo
Wednesday
John Sheehan commented on John Sheehan's photo
Thumbnail

24inMiddle N Trolled

"Thanks Jeff been too long .This day is what we needed!"
Wednesday
Jeffrey D. Abney commented on John Sheehan's photo
Thumbnail

24inMiddle N Trolled

"Very nice day on the water…..quality fish…..crappie slabbage……congrats…"
Wednesday
John Sheehan posted photos
Tuesday
Jeffrey D. Abney posted a photo

Good Box of Tidal Crappie and Bonus Channel Cat……..8/16/2022

We’ve had multiple cold fronts back to back…..and accompanying rainfall which has pushed our…
Tuesday
Jeffrey D. Abney commented on Jeffrey D. Abney's photo
Thumbnail

Cody Goes Coppernose….8/14/2022

"Thanks Bruce and John, we enjoyed a very comfortable morning with a good bite…..I might have…"
Monday
John Sheehan commented on Jeffrey D. Abney's photo
Thumbnail

Cody Goes Coppernose….8/14/2022

"Nice work Jeff and Cody!"
Monday
Bruce Tomaselli commented on Jeffrey D. Abney's photo
Monday
Jeffrey D. Abney posted photos
Sunday
Jeffrey D. Abney posted a photo

Cody Tagged a Nice Warmouth…8/14/2022

Everything caught on live cricket tipped jigs ….surface temperatures down to 77 in this creek,…
Sunday
Jeffrey D. Abney posted a photo

Several Doubles This Morning….8/14/2022

I enjoyed seeing Cody figure out the pattern this morning…
Sunday
Jeffrey D. Abney posted photos
Sunday

© 2022   Created by Bluegill.   Powered by

Badges  |  Report an Issue  |  Terms of Service